Fluke Corporation                                           MET/CAL Procedure
=============================================================================
INSTRUMENT:            Fluke 8: CAL ADJ /5100
INSTRUMENT:            Fluke 10: CAL ADJ /5100
INSTRUMENT:            Fluke 11: CAL ADJ /5100
INSTRUMENT:            Fluke 12: CAL ADJ /5100
INSTRUMENT:            Fluke 12B: CAL ADJ /5100
INSTRUMENT:            Fluke 18: CAL ADJ /5100
DATE:                  19-Aug-96
AUTHOR:                Fluke Corporation
REVISION:              $Revision: 2.3 $
ADJUSTMENT THRESHOLD:  70%
NUMBER OF TESTS:       1
NUMBER OF LINES:       64
CONFIGURATION:         Fluke 5100B
=============================================================================
#
# Source:
#   Fluke 10 Series Service Manual (PN 900824 March 1992, Rev. 1, 7/93).
#
# Compatibility:
#   MET/CAL 4.0 or later
#
# Subprocedures:
#   None
#
# Required Files:
#   None
#
# System Specifications:
#   TUR calculation is based on specification interval of the accuracy file.
#   The default 5100B accuracy file contains 6 month specs.
#
# Fluke makes no warranty, expressed or implied, as to the fitness
# or suitability of this procedure in the customer's application.
#
# The 6 month specifications of the 5100B are used in TUR computations.
#
 STEP    FSC    RANGE NOMINAL        TOLERANCE     MOD1        MOD2  3  4 CON
  1.001  HEAD         CALIBRATION ACCESS PROCEDURE
  1.002  DISP         Remove any input signals to the meter and turn off.
  1.002  DISP
  1.002  DISP         Remove the four screws on the back and separate the
  1.002  DISP         case bottom and case top.
  1.002  DISP
  1.002  DISP         Notice that when you do so the battery remains in the
  1.002  DISP         case bottom and power to the meter is disconnected.
  1.003  DISP         Observing correct polarity, connect a 9V battery to the
  1.003  DISP         battery contacts using easy hook junpers or alligator
  1.003  DISP         clip leads.
  1.003  DISP
  1.003  DISP         [32]                      NOTE
  1.003  DISP         To avoid stretching or bending the battery contacts,
  1.003  DISP         connect leads to the base of the contacts.
  1.004  HEAD         EQUIPMENT SETUP
  1.005  DISP         Ambient temperature: 18C - 28C.
  1.005  DISP         Relative humidity: less than 80%.
  1.005  DISP         Allow the UUT to stabilize.
  1.006  HEAD         CALIBRATION PROCEDURE
  1.007  DISP         Move the Slide-Switch to the center position.
  1.007  DISP         Press RANGE to select the 4V Range.
  1.008  5100         4V                                                S  2W
  1.009  DISP         Adjust R4 reading of 4.000+/-0.003V.
  1.010  END